Desalination Units

Our manual unit has been designed to cater not only for customers with a budget in mind, but also specifically for customers who are generally around their properties most of the time, enabling them to keep a casual perusal over their desalination plant as it is operating.

The new manual unit is housed in a framework the same as the fully automatic, your production from the manual unit is no different to that of the automatic unit, given the same water quality and cleans your water just as thoroughly as the automatic. You are also able to increase your membrane capacity at a later stage, should you choose to do so.  

You also need to be aware that it runs on 240 volt 15 amp power due to the larger 3 hp motor.

Our Model AU4HP10M is a fully automated computerised unit ideally suited for the customer who chooses to have the freedom to be away from their property and desal unit, either for work or for holidays.

Knowing that as long as they have an automated irrigation system to also back it up, they can rely on the two working together in unisent. As with Model A, you have the ability to produce anywhere from 8,000 through to 50,000 litres per day, as long as their water quality is adequate.

It's computerized program will shut down you're your unit should any problems arise, display any problems once detected on the front display panel, as well as allow you to only have it run at specific times of the day.

This model has been designed to fill the production void for customers who are initially looking for a unit that will produce for them say 30,000 litres per day.

Then also allows them to upgrade their capacity of membranes upwards to 15, allowing them (given the correct water quality) to increase their daily output to 90,000 litres per day.

Model AU8HP20M that this is a single unit with 2 inner modules containing either 2 x 4 hp motors or 2 x 5hp motors as well, with the ability to hold up 24 membranes if required.

This unit is suitable for situations where the customer requires say 80,000-140,000 litres per day, however has water with a higher salinity level and simply requires that extra bit of power.

With these models, you are looking specifically at custom designed units. Upwards to 40 membranes, which will deliver for the customer, (again given the appropriate water quality), anywhere up to 300,000 litres per day.

These units are  self regulating machines, where with their computers, are able to start and stop their own production under their own steam, simply by keeping an eye on their water storage tanks which they are supplying. Any problems should they occur, are displayed on the front panel, and its membranes are better protected because the unit receives a back flush each time it finishes  a cycle of production.

These industrial designed desalination units, will basically be made of one individual unit, but with inner modules (each containing upwards of 10 membranes).

It is programmed with 2 modes of operation. The 1st allowing either each module to operate individually, or your 2nd mode is where your unit will operate, all as one. Benefit of this of course, is that one or more modules can be stopped, while one of the modules can be serviced. Our desalination unit also, is designed so that when it fires up, the computer will start each module separately, each of the multistage motors approximately 2 seconds after each one, allowing for a more gentle drain on your power source.